earticle

논문검색

공학/가공/관능검사

전해인자에 따른 전기분해수의 특성 비교

원문정보

Comparison of Characteristics on Electrolyzed Water Manufactured by Various Electrolytic Factors

김명호, 정진웅, 조영제

피인용수 : 0(자료제공 : 네이버학술정보)

초록

영어

Efficacy of surface sterilization and physicochemical properties of electrolyzed water manufactured depending on electrolyte, materials, and type of electrolytic diaphragm used were investigated. Physical properties of electrolyzed water manufactured from diaphragm system showed the highest effectiveness under at distance between diaphragms of 1.0 mm and 20% NaCl supplying rate of 6 mL/min. ORP, HClO (should defined) content, and pH at above conditions were 1,170 mV, 100 ppm, and 2.5, respectively. Two-stage electrolyzed system was more effective than one-stage one. Electrolyzed water manufactured from non-diaphragm system at 4 mL/min supplying rate of 20% NaCl was similar to the most effective diaphragm system, whereas ORP, HClO content, and pH were 800 mV, 200 ppm, and 9, respectively. Sealed electrolyzed water could be preserved more than one month at room temperature with ORPs of 750 and 1,150 mV in non-diaphragm and diaphragm systems, respectively, and at HClO content of 100 ppm. Physicochemical properties of electrolyzed water manufactured from electrolytic diaphragm of IrO2 and Pt+Ir were more effective than that of Pt. ORP and HClO contents of electrolyzed water manufactured from various electrolytes were high in order of NaCl>KCl>CaCl2, whereas no differences were observed among electrolytes in sterilization efficacy. Twelve kinds of microorganisms tested (initial total count, 105-106CFU/mL) were sterilized within 1-2 min by electrolyzed water.

한국어

본 연구에서는 전해 격막의 방식 및 재질, 전해액에 따른 전기분해수의 물리적 특성과 미생물의 표면살균 효과를 검토하였다. 격막 방식의 전기분해수 제조 시스템의 최적조건은 간극이 1.0mm, 20% NaCl 첨가량이 6mL/min 일 때 제조된 전기분해수의 물성치가 ORP 1,170mV 수준, HClO 함량 100ppm 수준, pH 2.5 수준으로 가장 우수하게 나타났으며, 1단 방식보다는 2단의 전기분해 방식이 물성 측면에서 우수함을 알 수 있었다. 무격막 방식의 전기분해수는 간극이 1.0mm, 20% NaCl 첨가량이 4mL/min 일 때 격막 방식의 최적조건과 가장 유사하게 나타났으나 차아염소산 함량은 132-266ppm 수준, pH는 9 수준으로 격막 방식과는 크게 달라지는 것을 알 수 있었다. 전극의 재질에 따른 성능을 평가한 결과, IrO2 및 Pt+Ir 재질의 극판이 산화환원전위 1,144-1,142mV 수준, 차아염소간 함량 190-235ppm 수준, pH 2.24-2.73으로 Pt 재질에 비해 물성치가 다소 높음을 볼 수 있으며 제조 수량도 가장 양호하게 나타났다. 전극판의 재질 특성에 따라 제조한 전기분해수의 미생물 살균효과는 Salmonella typhimurium을 제외한 나머지 3균주는 초기 107-109CFU/mL에서 30초 후에 모두 사멸되는 것으로 나타났으나, Salmonella typhimurium는 IrO2 재질에서는 1-2분 이내에 사멸되었다. 전해액으로 NaCl 및 CaCl2, KCl을 사용하여 제조한 전기분해수의 ORP및 HClO 함량은 NaCl, KCl, CaCl2 순으로 높게 나타났으나 큰 차이는 없었으며, 미생물 사멸효과는 동일하게 나타났다.

저자정보

  • 김명호 Kim, Myung-Ho. 한국식품개발연구원
  • 정진웅 Jeong, Jin-Woong. 한국식품개발연구원
  • 조영제 Cho, Young-Je. 부경대학교 식품생명공학부

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      ※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.

      0개의 논문이 장바구니에 담겼습니다.