원문정보
인크리스 레이어와 원랭스 투 블록 커트의 두상영역분할과 길이 및 슬라이스 라인에 따른 연구
초록
영어
Purpose: This study describes two-block cuts involving an increase layer cuts at the top of the head and one-length cuts at the bottom of the head. The changes in the shape line according to head area division, length and slice line was described. This study aimed to provide basic data on haircuts by demonstrating changes in cut design. Methods: The division of the head was divided into upper and lower parts. The starting points at the top of head were 15 cm from the top golden medium point, 20 cm from the golden point, and 25 cm from the golden back medium point and the angle of the head was 100°. The starting points at the bottom of the head were 10, 15, and 20 cm, and the natural angle of operation was 0° at the nape point. The slice line was applied as a parallel line on the lower back of the head, and as an A line, a parallel line, and a V line on the side of the head. Results: A long hair with a low angle can give calmness and weight, whereas a short hair with a high angle can provide volume and liveliness. The one-length cut emphasizes an angular shape, smoothness, and orderliness as the hair falls on the same line. In contrast, an incremental layer cut can give a long stretched shape, rough texture, volume, and liveliness. Two-block cuts are unconnected cuts that offer a sense of mystery, uniqueness, and freshness. If the point of the head area division is placed on above, the hair length will decrease and if it is placed below, the hair length will increase. Conclusion: Smoothness increases with the number of one-length intervals. The increase layer cut is concave, which makes the face and the head look thinner. Long hair provides calmness whereas short hair offers volume. When dividing the head into parts, it is essential to determine the head and face type. In two-block cuts, if a head area division is placed above, the hair length will be shorter and appear as bangs. Contrarily, if the head split is placed below, the hair length increases. Furthermore, it is also thought that depending on how the texture is treated and how the drying method is done, it can appear as a connected cut.
한국어
목적: 본 연구는 두상 상단은 인크리스 레이어 커트, 두상 하단은 원랭스 커트를 혼합한 투 블록 커트이다. 두상영역분할과 길이 및 슬라이스 라인에 따른 형태선의 변화를 파악하고자 한다. 또한 커트 디자인의 변화를 실증하여 헤어커트 기초자료를 제공하는 데에 목적이 있다. 방법: 두상영역분할을 위와 아래로 구분하였다. 두상 상단은 두상시술각도 100°, 탑 골든 미디엄 포인트에서 15 cm, 골든 포인트에서 20 cm, 골든 백 미디엄 포인트에서 25 cm로 하였다. 두상 하단의 출발점은 네이프 포인트에서 10 cm, 15 cm, 20 cm, 자연시술각도 0°로 하였다. 슬라이스 라인은 두상 하단 후면은 평행라인 측면은 A라인, 평행라인, V라인을 적용하였다. 결과: 모발 길이가 길고 각도가 낮으면 차분함과 무게감, 길이가 짧고 각도가 높으면 볼륨감과 생동감을 줄 수 있다. 원랭스 커트는 동일 선상에 모발이 떨어져 각진 형태와 매끄러움 그리고 가지런함을 상징한다. 인크리스 레이어 커트는 길게 늘어진 형태와 거친 질감, 볼륨감, 생동감을 줄 수 있다. 투 블록 커트는 연결되지 않는 커트로 신비감, 독특함, 신선함을 줄 수 있다. 두상영역분할 지점을 위 에 두면 모발 길이가 짧아지고 아래에 두면 모발 길이가 길어진다. 결론: 원랭스 구간이 많을수록 매끄러움은 증가한다. 인크리스는 오목한 형태로 얼굴형과 두상 형을 가름하게 보이는 효과가 있다. 그리고 모발 길이를 길게 하면 차분함, 모발 길이를 짧게 하면 볼 륨감을 연출할 수 있다. 두상분할 시 두상 형과 얼굴형을 파악해서 결정해야 될 것으로 사료된다. 투 블록 커트에서 두상분할을 위 에 두면 모발 길이가 짧아지고 앞머리 형태로 나타난다. 반면 두상분할을 아래에 두면 모발 길이가 길어진다. 또한 질감처리와 드라 이 방식을 어떻게 하느냐에 따라 연결된 커트로 보일 수도 있다고 사료된다
중국어
目的: 本研究描述了一种双区块剪发,即头顶增量分层剪发,头底单一长度剪发。研究描述了形状线随头部分 区、长度和切片线的变化。本研究旨在通过展示剪发设计的变化,为发型设计提供基础数据。方法: 将头部分为 上、下两部分。头顶起始点分别为距头部黄金中点15 cm、距黄金中点20 cm、距背部黄金中点25 cm,头部角 度为100°。头底起始点分别为距头部10、15、20 cm,自然操作角度为颈背点0°。在头后下方,切片线为平行 线;在头侧,切片线为A线、平行线、V线。结果: 低角度的长发能营造沉稳厚重的感觉,而高角度的短发则能 带来蓬松感和活力。单一长度剪发强调棱角分明、顺滑有序的造型,因为头发垂落在同一条线上。相比之下, 增量分层剪发则能打造修长舒展的造型、粗犷的质感、蓬松感和活力感。双区块剪发是不相连的剪发,营造出 一种神秘、独特和清新的感觉。如果头部区域划分点位于上方,头发长度会缩短;如果位于下方,头发长度会 延长。结论: 随着单一长度部分越多,头发的顺滑度也随之增加。增量分层剪发呈凹形,起到脸型和头型偏瘦。 长发带来沉稳感,而短发则带来蓬松感。将头部区域分割时,必须确定头型和脸型。在双区块剪发中,如果将 头部分叉放在上方,头发长度会较短,看起来像刘海。相反,如果将头部分叉放在下方,头发长度会增加。此 外,根据纹理处理方式和吹风方法的不同,头发可能会呈现出连续的剪发效果。
목차
Introduction
Methods
1. 측정도구 및 방법
2. 두상 하단 원랭스 커트와 두상 상단 인크리스 레이어 커트의 투블록형태로 두상영역분할, 길이, 슬라이스 라인에 따른 디자인 변화
Results and Discussion
1. TGM 두상영역분할에 따른 인크리스 레이어 커트와 원랭스 커트의 형태변화
2. G 두상영역분할에 따른 인크리스 레이어 커트와 원랭스 커트의형태변화
3. GBM 두상영역분할에 따른 유니폼 레이어 커트와 원랭스 커트의 형태변화
4. 인크리스 레이어 커트와 원랭스 커트 투 블록 커트의 두상영역분할, 길이, 슬라이스 라인에 따른 변화
Conclusion
References
국문초록
참고문헌
中文摘要
