원문정보
투 블록 형태로 유니폼 레이어 커트와 원랭스 커트의 두상영역분할, 길이, 슬라이스 라인에 따른 디자인 연구
초록
영어
Purpose: This study focuses on the two-block haircut, characterized by a uniform layer cut on top of the head and a one-length cut in the bottom of the head. The proposed haircut serves as a foundational reference by demonstrating its changes across three head areas, lengths, and slice lines. Methods: Based on the top golden medium point, golden point, and golden back medium point, the head was divided in to two part, and the upper part was named the top of head with lengths of 5, 20, and 25 cm and the lower part was named the bottom of head with lengths of 25, 20, and 15 cm. For the slice line, a parallel line was applied to the rear of the head and an A line, parallel line, and V line were applied to the side surface of the head. Results: The top of the head featured a uniform layer cut, with a rough texture and rounded shape, at a uniform length. At the bottom of the head with a one-length cut, smoothness, orderliness, and an angular shape were observed. The A line had longer hair extending toward the face line, creating a thin shape, while the parallel line had a flat shape. The V line featured a distinct round shape with shorter hair as it goes toward the face line. The two-block cuts appeared unconnected, giving them a sense of uniqueness, mystery, and freshness. Conclusion: A one-length cut creates smoothness and an angular shape, while a uniform layer cut achieved the same length with a rough texture. To smooth the connection line in a two-block haircut, it is essential to extend the hair and segment the head area down. When dividing the head area and selecting the length and slice line, it is necessary to do so according to head shape, face shape, hair quality, and the customer’s taste. It is possible to reduce the number of errors by correcting the combing from the root of the hair and standing in a frontal position when cutting rather than cutting it. The length of the haircut’s starting point is closely related to the final overall length and shape. These findings should be further investigated through research into three-block haircuts.
한국어
목적: 본 연구의 형태는 투 블록 커트이며 두상 상단은 유니폼 레이어 커트와 두상 하단은 원랭스 커트이다. 3개의 길이와 3개의 슬 라이스 라인 그리고 3개의 두상영역분할에 따른 변화를 실증하여 헤어커트 기초자료를 제공하는 데에 목적이 있다. 방법: 탑 골든 미디엄 포인트, 골든 포인트, 골든 백 미디엄 포인트를 기점으로 두상 위를 상단으로 명명하였고 모발 길이는 5 cm, 20 cm, 25 cm 로 하였다. 두상 아래를 하단으로 명명하였고 모발 길이는 25 cm, 20 cm, 15 cm로 하였다. 슬라이스 라인은 두상 후면은 평행라 인 두상 측면(옆면)은 A라인, 평행라인, V라인을 적용시켰다. 결과: 두상 상단은 유니폼 레이어 커트로 거친 질감과 모발 길이가 동 일한 둥근 형태로 관찰되었다. 두상 하단은 원랭스 커트로 매끄러움과 가지런함 및 각진 모양이 관찰되었다. A라인은 얼굴 라인으 로 갈수록 모발이 길어져 가름한 형태 평행라인은 반듯한 형태 그리고, V라인은 얼굴 라인으로 갈수록 모발이 짧아져 귀여운 형태 로 관찰되었다. 투 블록 커트는 서로 연결되지 않아서 독특함, 신비감, 신선함을 주는 것으로 관찰되었다. 결론: 원랭스 커트는 매끄 러움과 각진 형태를 나타내고 유니폼 레이어 커트는 거친 질감과 동일한 길이를 상징한다. 투 블록 커트 시 연결선을 매끄럽게 하고 싶다면 두상영역분할을 아래로 두고 모발 길이를 길게 해야 된다고 판단된다. 두상영역분할과 길이 및 슬라이스 라인 선정 시 두상 형과 얼굴형 및 모질 그리고, 고객취향에 맞게 디자인을 해야 할 것으로 사료된다. 커트 시 자르는 것보다 모근 뿌리에서부터 빗질 을 정확하게 하고, 몸 위치가 정면에 서서 커트를 해야 오차를 줄일 수 있다고 사료된다. 커트 출발점의 길이는 전체적인 길이와 형 태에 밀접하고 향후에는 쓰리블록 연구가 활발히 이루어질 바라는 바이다
중국어
目的: 本研究重点关注两块发型,其特点是头顶剪成均匀的层次,头底剪成一个长度。建议的发型通过展示三个 头部区域、长度和切片线的变化,作为基础参考。方法: 以头部顶部黄金中点、黄金中点、黄金后中点为界,将 头部分为两部分,上部称为头顶,长度分别为5、20、25cm,下部称为头底,长度分别为25、20、15cm;切 线方面,在头部后方应用平行线,在头部侧面应用A线、平行线、V线。结果: 头顶为均匀的层次剪裁,质地粗 糙,造型圆润,长度均匀;头底为齐长剪裁,光滑整齐,造型有棱有角;A字形头发较长,向脸部延伸,造型纤 细;平行形头发较平;V字形造型明显,向脸部延伸,头发较短;两块剪裁互不相连,给人一种独特、神秘、清 新的感觉。结论: 单一长度的剪发可以打造光滑且有棱角的形状,而均匀的分层剪发可以实现相同的长度但质地 粗糙。为了使两块发型中的连接线变得平滑,必须延长头发并向下分割头部区域。在划分头部区域并选择长度 和切片线时,需要根据头型、脸型、发质和顾客的品味进行。通过从发根开始梳理头发并在剪发时站在正面而 不是直接剪发,可以减少错误。发型起点的长度与最终的整体长度和形状密切相关。这些发现应该通过对三块 发型的研究进一步证实。
목차
Introduction
Methods
1. 측정도구 및 방법
2. 투 블록 커트 형태로 두상 상단은 유니폼 레이어 커트와 두상 하단은 원랭스 커트로 두상영역분할, 길이, 슬라이스 라인에 따른 디자인 형태
Results and Discussion
1. TGM 두상영역분할에 따른 유니폼 레이어 커트와 원랭스 커트의 형태변화
2. G 두상영역분할에 따른 유니폼 레이어 커트와 원랭스 커트의형태변화
3. GBM 두상영역분할에 따른 유니폼 레이어 커트와 원랭스 커트의 형태변화
4. 투 블록 커트로 두상 상단 유니폼 레이어 커트와 두상 하단 원랭스 커트의 두상영역분할과 길이 및 슬라이스 라인에 따른 변화
Conclusion
References
국문초록
참고문헌
中文摘要
