earticle

영어

In this study, in order to confirm the machining characteristics of AISI 1020 CD-Bar, cutting was performed after strength measurement, and surface roughness analysis was performed according to cutting conditions. Tensile strength was reduced by about 27.7% compared to AISI 1045 material, and Rockwell hardness HRC was reduced by 46.7%. The surface roughness measurement after cutting was divided into roughing, semi-finishing and finishing turning. In particular, in finishing machining, the best surface roughness was confirmed when the cutting speed was 150m/min and the depth of cut was 0.6mm based on the feed rate of 0.05mm/rev.