원문정보
초록
영어
In this study, the design of fuel tanks for SUVs (sports utility vehicles) was dealt with through structural analysis. Fuel tank analysis was performed to evaluate safety, and improvement plans for weak areas were found and reflected in the design. In addition, strength analysis and pressure analysis were performed in parallel to solve the problem of oil leakage around the lower part of the fuel tank and the rear mounting that occurred during the endurance test, and the analysis results were reflected in the design. As a result of analysis through various design changes, it was possible to present an appropriate reinforcement flange shape. In addition, when the thickness of the fuel tank was changed from 1.0mm to 0.8mm, the stiffness of the fuel tank decreased by approximately 30%, and reinforcement was required.
목차
1. 서론
2. 부품 설계
2.1 연료탱크 설계 조건
2.2 연료탱크 해석 방법
3. 해석결과 및 고찰
3.1 연료탱크 강도해석 결과
3.2 연료탱크 압력해석 결과
4. 결론
후기
References
저자정보
참고문헌
- 1K. J. Kim, Y. H. Lee and I.- S. Sohn, “Hydro- forming Process of Automotive Rear Sub-frame by Computer Aided Engineering (CAE)”, KSAE, Vol. 16, No. 3, pp. 38-43, 2008
- 2F. Dohmann, Ch. Hartl, “Tube hydroforming- research and practical application”, J. Mater. Process. Tech.. Vol. 71 pp. 174-186, 1997
- 3K. J. Kim, B.-I. Choi, C. W. Sung, “Hydro- forming Process of Automotive Engine Cradle by Computer Aided Engineering (CAE)”, KSAE, Vol. 16, No. 1, pp. 86-92, 2008
- 4K. J. Kim, J. h. Kim, B.-I. Choi, “Hydro-forming Process Development of Automotive AA6061 Rear Sub-frame Side Member by Computer Aided Engineering (CAE)”, KSAE, Vol. 18, No. 5, pp. 45-49, 2010
- 5C. W. Sung and Y. N. Paik, “Hydro-Forming Simulation of Automotive Rear Sub-frame Cross Members”, KSMT, Vol. 10, No. 2, pp. 9-14, 2008
- 6M. Cerit and M. Coban, “Temperature and thermal stress analyses of a ceramic-coated aluminum alloy piston used in a diesel engine”, International Journal of Thermal Sciences, Vol. 77, pp. 11-18, 2014
- 7B. Zhao, “Thermal Stress Analysis of Ceramic- Coated Diesel Engine Pistons on the Wavelet Finite-Element Method, Journal of Engineering Mechanics, Vol. 138, No. 1, pp. 143-149, 2012
- 8K. J. Kim, “Light-Weight Design of Automotive Wheel Carrier by Using CAE”, J. KSMT, Vol. 18, No. 4, pp. 543-549, 2016
- 9K. J. Kim, “Fatigue Safety Design of Automotive Torque Strut by Using CAE Static Analysis”, J. KSMT, Vol. 18, No. 5, pp. 694-699, 2016