원문정보
초록
영어
In this study, using a 100mm gauge block in a contact-type three-dimensional measuring machine surface plate, an NPL-type angle measurement, and a steel ruler, the specimen was measured at 0°, 5°, 10°, 20°, 30°, and 40° along the X and Y axes. After setting the measurement conditions, the average value and standard deviation were confirmed by repeating measurements for each yield 10 times. After checking the statistical test value (P) through ANOVA, the correlation between the angle change and the error was checked.
목차
ABSTRACT
1. 서론
2. 실험 장비 및 방법
2.1 실험장비 및 측정시편
2.2 실험조건
3. 결과 및 고찰
3.1 X축 방향 각도별 측정오차 분석
3.2 Y축 방향 각도별 측정오차 분석
4. 결론
References
1. 서론
2. 실험 장비 및 방법
2.1 실험장비 및 측정시편
2.2 실험조건
3. 결과 및 고찰
3.1 X축 방향 각도별 측정오차 분석
3.2 Y축 방향 각도별 측정오차 분석
4. 결론
References
저자정보
참고문헌
자료제공 : 네이버학술정보