원문정보
Analysis of deformation according to post-curing of complete arch artificial teeth for temporary dentures printed with a DLP printer
초록
영어
Purpose: This study aimed to analyze deformation according to post-curing of complete arch artificial teeth for temporary dentures printed with a digital light processing (DLP) printer. Methods: An edentulous model was prepared and an occlusal rim was produced. The edentulous model and occlusal rim were scanned using a model scanner. A complete denture was designed using a dental computer-aided design, and the denture base and artificial tooth were separated. Ten complete arch artificial teeth were printed using a 3D printer (DLP). Complete arch artificial teeth was classified into the following three groups: a group no post-curing (NC), a group with 10 minutes post-curing (10M), and a group with 20 minutes post-curing (20M). Specimens were scanned using a model scanner. The scanned data were overlapped with the reference data. Statistical analysis was performed using one-way ANOVA analysis of variance, Kruskal–Wallis test, and Mann–Whitney U test (α=0.05). Results: Regarding the overall deviation of complete arch artificial teeth, the NC group showed the lowest mean deviation of 111.13 μm and the 20M group showed the highest mean deviation of 131.03 μm. There were statistically significant differences among the three groups (p<0.05). Conclusion: The complete arch artificial tooth showed deformation due to post-curing. In addition, the largest shrinkage deformation was observed at 10 minutes of post-curing, whereas the least deformation was observed at 20 minutes.
목차
INTRODUCTION
MATERIALS AND METHODS
1. 주모형 선정
2. 연구모형 제작
3. 기초상 제작 및 교합제 제작
4. 스캔(scan) 및 디자인(design)
5. 3D 프린팅을 사용하여 출력
6. 전악 인공치아 스캔 및 후경화
7. 3D 중첩
8. 통계분석
RESULTS
DISCUSSION
CONCLUSION
CONFLICT OF INTERESTS
ORCID
REFERENCES