earticle

논문검색

<학술연구>

다구찌 방법을 이용한 자동차플라스틱 라디에이터 탱크의 변형 최적화

원문정보

Optimization of Deformation of Automotive Plastic Radiator Tank using Taguchi Method

이용선, 한성렬

피인용수 : 0(자료제공 : 네이버학술정보)

초록

영어

This study wanted to optimize the radiator tank's deformation assembled on the automotive engine block. Among the experimental planning methods, the Taguchi method was used to find optimal molding conditions to minimize plastic covers' deformation. The four main factors used in the Taguchi method were selected as the main factors: resin temperature, pressure time, coolant temperature, and cooling time. The number of cycles for each factor was divided into five stages, and a total of 25 experiments were conducted. The experiment used the Moldflow program, an injection molding analysis program. The maximum deformation obtained under the existing molding conditions was about 1.318mm. Still, the deformation of the mold applied with the optimal molding conditions obtained using the Taguchi method was approximately 1.273mm, which showed that the maximum deformation was reduced by 3.4% compared to the existing molding conditions.

목차

ABSTRACT
1. 서론
2. 라디에이터 탱크의 성형해석
2.1 라디에이터 탱크의 구조
2.2 라디에이터 탱크의 성형해석
3. 다구찌 방법과 결과 비교
3.1 다구찌 방법
3.2 사출성형 해석 및 결과 분석
4. 결론
References

저자정보

  • 이용선 Yong-Sun Lee. Department of Optical Egineering and Metal Mold, Kongju National University
  • 한성렬 Seong-Ryeol Han. Member, Associate Professor, Kongju National University

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      ※ 기관로그인 시 무료 이용이 가능합니다.

      • 4,000원

      0개의 논문이 장바구니에 담겼습니다.