earticle

논문검색

Original Article

가연성 액체 혼합물의 인화 위험성에 관한 연구

원문정보

A Study on Flammability Risk of Flammable Liquid Mixture

김주석, 고재선

피인용수 : 0(자료제공 : 네이버학술정보)

초록

영어

Purpose: In this study, the risk of flammability of a liquid mixture was experimentally confirmed because the purpose of this study was to confirm the increase or decrease of the flammability risk in a mixture of two substances (combustible+combustible) and to present the risk of the mixture. Method: Flash point test method and result processing were tested based on KS M 2010-2008, a tag sealing test method used as a flash point test method for crude oil and petroleum products. The manufacturer of the equipment used in this experiment was Japan's TANAKA. The flash point was measured with a test equipment that satisfies the test standards of KS M 2010 with equipment produced by the company, and LP gas was used as the ignition source and water as the cooling water. In addition, when measuring the flash point, the temperature of the cooling water was tested using cooling water of about 2°C. Results: First of all, in the case of flammable + combustible mixtures, there was little change in flash point if the flash point difference between the two substances was not large, and if the flash point difference between the two substances was low, the flash point tended to increase as the number of substances with high flash point increased. However, in the case of toluene and methanol, the flash point of the mixture was lower than that of the material with a lower flash point. Also, in the case of a paint thinner, it was not easy to predict the flash point of the material because it was composed of a mixture, but as a result of experimental measurement, it was measured between -24℃ and 7℃. Conclusion: The results of this study are to determine the risk of mixtures through experimental studies on flammable mixtures for the purpose of securing the effectiveness of the details of the criteria for determining dangerous goods in the existing dangerous goods safety management method and securing the reliability and reproducibility of the determination of dangerous goods Criteria have been presented, and reference data on experimental criteria for flammable liquids that are regulated in firefighting sites can be provided. In addition, if this study accumulates know-how on differences in test methods, it is expected that it can be used as a basis for research on risk assessment of dangerous goods and as a basis for research on dangerous goods determination.

한국어

연구목적: 본 연구에서는 두 물질의 혼합물(가연물+가연물)에서의 인화 위험성의 증가 또는 감소를 실 험적으로 확인하고, 혼합물의 위험성을 제시하는 목적이 있기에 액체 혼합물의 인화 위험성을 실험적으로 확인하였다. 연구방법: 인화점 실험방법 및 결과처리는 원유 및 석유 제품 인화점 시험 방법으로 사용되고 있는 테그밀폐식 시험방법인 KS M 2010-2008을 기준으로 실험하였다. 본 실험에 사용한 장비의 제조사는 일본의 TANAKA사에서 생산한 장비로 KS M 2010의 시험규 격을 만족하는 시험장비로 인화점을 측정하였고, 점화원으로는 LP가스를, 냉각수로는 물을 사용하였다. 또한 인화점 측정시 냉각수의 온도 는 약 2℃의 냉각수를 사용하여 실험을 진행하였다. 연구결과: 실험결과로는 먼저 가연성+가연성 혼합물의 경우 두 물질의 인화점 차이가 크 지 않으면 인화점의 변화가 거의 없었고, 두 물질의 인화점 차이가 낮으면 인화점이 높은 물질의 증가에 따라 인화점이 증가하는 경향을 보였 으나, 톨루엔과 메탄올의 경우, 혼합물에서 인화점이 낮은 물질보다 더 낮은 인화점을 보였다. 또한 도료용 희석제의 경우, 혼합물로 이루어 져서 그 물질의 인화점을 예상하기가 쉽지 않았지만 실험적으로 측정해 본 결과 -24℃~7℃사이로 측정되었다. 결론: 본 연구에서의 결과는 기존의 위험물안전관리법에서의 위험물 판정 기준에 대한 세부 내용의 실효성 확보 및 위험물 판정의 신뢰성 및 재현성 확보를 목적으로 인 화성 혼합물에 대한 실험적 연구를 통해서 혼합물에 대한 위험성 판단 기준을 제시하였고, 향후 소방현장에서 단속되는 인화성 액체 대한 실 험적 판정 기준에 대한 참고적인 자료를 제공할 수 있을 것이다. 또한 본 연구로 시험방법별 차이 실험에 대한 노하우를 축적한다면 위험물의 위험성 평가 연구에 있어 기초 자료이자 위험물 판정 관한 연구의 기반으로 활용될 수 있기를 기대한다.

목차

ABSTRACT
요약
서론
연구배경
연구범위 및 목적
실험방법 및 재료
가연성+가연성 액체 혼합물
알코올+알코올 혼합물 인화 위험성
유기용제 혼합물 인화 위험성
알콜+방향족 유기용제 혼합물 인화 위험성
연구결과 고찰
가연성혼합물의 혼합에 따라 발생하는 인화위험성의 변화 결과
도료용 희석제 및 그 혼합물의 인화 위험성 결과
혼합물의 불확실성에 대한 결과
References

저자정보

  • 김주석 Ju Suk Kim. Junior Researcher Official, Fire Safety Research Division, National Fire Research Institute, Asan, Republic of Korea
  • 고재선 Jae Sun Koh. Professor, Department of Fire Safety, University of Howon, Gunsan, Republic of Korea

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      ※ 기관로그인 시 무료 이용이 가능합니다.

      • 4,200원

      0개의 논문이 장바구니에 담겼습니다.