earticle

논문검색

Six-port 직접 변환 수신을 위한 광대역 Power detector 설계 제작

원문정보

Design and Implementation of Broadband Power Detector for Six-port Direct Conversion Receiver

이용주, 김영완, 박동철

피인용수 : 0(자료제공 : 네이버학술정보)

초록

영어

The broadband power detector for power amplitude envelope detection of the direct-conversion Six-port output signal was designed and implemented in this paper. The power detector should be linearly operated to produce the linear amplitude and phase signal for input RF signals in required broadband frequency range. The power detector should be designed under conditions of matching circuit with low VSWR, which protect unbalanced phase signal from reflection signal due to mismatch between the output port of a six-port and the input port of a power detector. The designed power detectors, which were implemented in L-band with 50 ohm matching and Ku-band with multiple LC matching circuits and isolator, respectively, were analyzed in viewpoints of the utilization as a power detector of direct conversion Six-port. The dynamic range of designed power detectors were also measured and rvaluated as a power detector of Six-port circuit.

한국어

본 논문에서는 직접 변환 방식인 six-port의 RF 출력 신호를 검파하고 요구 대역폭에서 입력 주파수 신호에 대한 진폭 및 위상 신호를 선형적으로 출력하는 광역 power detector를 설계 제작한다. Six-port 출력단에 접속되는 power detector는 높은 정합도를 갖고 반사파로 인한 Six-port 간 위상 불일치를 방지하고, 넓은 대역폭에서 낮은 VSWR을 유지하여야 하는 광역 특성을 갖는 power detector 설계가 필요하다. 광역 정합을 위하여 사용 주파수 대역에 따라 강제 정합과 다단 LC 정합 회로, 그리고 isolator를 사용한 낮은 VSWR 특성을 갖는 설계 방법을 비교 분석한다. 설계 제작된 power detector의 주파수 대역에 대한 동적 동작 영역(dynamic range) 성능을 측정하여 Six-port의 수신 전송 신호 검파기로 활용될 수 있는 타당성을 평가한다.

목차

요약
 ABSTRACT
 I. 서론
 II. Power detector 설계
  1. L-band
  2. Ku-band
 III. 제작 및 실험
 IV. 결론
 참고문헌

저자정보

  • 이용주 Yoong-ju Lee. 한국폴리텍대학 메카트로닉스 공학과
  • 김영완 Young-wan Kim. 군산대학교 전자정보공학부
  • 박동철 Dong-chul Park. 충남대학교 전자공학과

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      ※ 기관로그인 시 무료 이용이 가능합니다.

      • 4,000원

      0개의 논문이 장바구니에 담겼습니다.