earticle

논문검색

<학술연구>

솔레노이드 인젝터와 피에조 인젝터의 파형과 분사량 분석을 위한 실험적 연구

원문정보

An Experimental Study on the Waveform and Injection Quantity Analysis of Solenoid Injector and Piezo Injector

강성구, 김철수

피인용수 : 0(자료제공 : 네이버학술정보)

초록

영어

In this paper, we investigate the relationship between control system of Bosch system and that of Delphi system by measuring the high and low voltage waveform, current waveform and fuel injection quantity of D-2 and R- engines. Waveform measurements are used the PICO scope and the CDS tester. The injectors of D-2 and R-engines were tested under no load condition using injector with normal fuel injection quantity, injector with small fuel injection quantity and injector with many fuel injection quantity. The relation between current energy and fuel injection quantity shows that the injector variation rate of D2-engine is much larger than that of R-engine. The injector current energy of the D2-engine was more linear than that of the R-engine, therefore making the system more stable. Although the control system of the D2-engine is a more stable system only in terms of the durability of the internal parts of the injector, the injector of the R-engine has a good response because the current value is large.

목차

ABSTRACT
1. 서론
2. 이론적 연구
2.1 제어 회로
2.2 피에조 인젝터의 이론 전압파형과 전류파형
3. 실험장치의 구성과 방법
3.1 실험 장비
3.2 실험 방법
4. 실험결과 및 고찰
5. 결론
References

저자정보

  • 강성구 Sung-Gu Kang. Member, Department of Automotive Engineering of Korea Polytechnics National University
  • 김철수 Chul-Soo Kim. Member, Department of Automotive Engineering of Gangneung-wonju National University

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      ※ 기관로그인 시 무료 이용이 가능합니다.

      • 4,000원

      0개의 논문이 장바구니에 담겼습니다.