원문정보
초록
영어
The objective of this study is to investigate the effect of tubular shaft hole length on the A-IMS production process in numerically. The hole length of tubular shaft was changed from 69.5mm to 79.5mm for distribution of load and stress. Then, the tubular shaft was modeled by S20C which was referred to program library. At the same time, the results of numerical analysis were compared in terms of under-fill, metal flow, principal stress, Von-mises stress and load characteristics. In the results, the load and stress were increased at 4 stage when the hole length of tubular shaft was increased. Also, folding phenomenon was observed to intensify as increasing the hole length of tubular shaft by confirmation of metal flow.
목차
ABSTRACT
1. 서론
2. 수치 해석적 연구 방법
2.1 각 제품의 형상 및 물성치
2.2 해석방법
3. 결과 및 고찰
3.1 결육(Under-fill) 특성
3.2 금속 유동선(Metalfl ow) 특성
3.3 하중(Load) 특성
3.4 주응력(Principals tress) 특성
3.5 등가응력(Von-mises stress) 특성
4. 결론
후기
References
1. 서론
2. 수치 해석적 연구 방법
2.1 각 제품의 형상 및 물성치
2.2 해석방법
3. 결과 및 고찰
3.1 결육(Under-fill) 특성
3.2 금속 유동선(Metalfl ow) 특성
3.3 하중(Load) 특성
3.4 주응력(Principals tress) 특성
3.5 등가응력(Von-mises stress) 특성
4. 결론
후기
References
키워드
저자정보
참고문헌
자료제공 : 네이버학술정보