원문정보
Performance Evaluation of VSI Attribute Control Chart for On-line Process Control
초록
영어
The proposed design method minimizes bias, i.e., an average time to signal for the shift of process from the target value (ATS) curve, as well as it applies a VSI method to an attribute control chart for detecting a process shift efficiently. First, the results of the factorial experiment obtained by various parameter circumstances show that the VSI control chart using nearly unbiased ATS design provides the smallest decreasing rate in ATS among other charts for all experimental cases. Second, we illustrate that the control limits on the VSI control vhart using Shewhart method cannot satisfy false alarms when control parameters are small. This problem causes process over-control, unnecessary costs increase, and changeful factor. While, about all parameter values, a nearly unbiased ATS design satisfies restrictions for given false alarm. Third, we represent that a process change is rapidly detected when short sampling interval approximate to min . In addition, the change of the sampling interval may not influence in a set of control chart parameters. Fourth, we demonstrate ATS curve has large bias establishing the parameter of VSI control chart using the Shewhart method. However, the proposed design method for the development of a control chart robust of sample size and control parameter size. Finally, We present an optimization model that may efficiently provide optimal ATS values for process parameters in a steady state, and that may efficiently establish parameters of correct control chart by supplying an optimization algorithm.
목차
Ⅱ. VSI 계수치 관리도의 근사 비편향 ATS 설계
Ⅲ. 수치실험 및 비편향성 평가
Ⅳ. 수행도 평가
Ⅴ. 결론
참고문헌
Abstract