earticle

논문검색

Technical Paper

Quantitative Evaluation of Radiation Dose Rates for Depleted Uranium in PRIDE Facility

원문정보

Il Je Cho, Jee Hyung Sim, Yong Soo Kim

피인용수 : 0(자료제공 : 네이버학술정보)

초록

영어

Background: Radiation dose rates in PRIDE facility is evaluated quantitatively for assessing radiation safety of workers because of large amounts of depleted uranium being handled in PRIDE facility. Even if direct radiation from depleted uranium is very low and will not expose a worker to significant amounts of external radiation. Materials and Methods: ORIGEN-ARP code was used for calculating the neutron and gamma source term being generated from depleted uranium (DU), and the MCNP5 code was used for calculating the neutron and gamma fluxes and dose rates. Results and Discussion: The neutron and gamma fluxes and dose rates due to DU on spherical surface of 30 cm radius were calculated with the variation of DU mass and density. In this calculation, an imaginary case in which DU density is zero was added to check the self-shielding effect of DU. In this case, the DU sphere was modeled as a point. In case of DU mixed with molten salt of 50-250 g, the neutron and gamma fluxes were calculated respectively. It was found that the molten salt contents in DU had little effect on the neutron and the gamma fluxes. The neutron and the gamma fluxes, under the respective conditions of 1 and 5 kg mass of DU, and 5 and 19.1 g.cm-3 density of DU, were calculated with the molten salt (LiCl+KCl) of 50 g fixed, and compared with the source term. As the results, similar tendency was found in neutron and gamma fluxes with the variation of DU mass and density when compared with source spectra, except their magnitudes. Conclusion: In the case of the DU mass over 5 kg, the dose rate was shown to be higher than the environmental dose rate. From these results, it is concluded that if a worker would do an experiment with DU having over 5 kg of mass, the worker should be careful in order not to be exposed to the radiation.

목차

ABSTRACT
 Introduction
 Materials and Methods
  1. Source term
  2. MCNP modeling
 Results and Discussions
  1. Flux and dose rate with the variation of DU density
  2. Flux and energy spectrum with the variation of molten salt content
  3. Flux and dose rate on the surface of SS316 container
 Conclusions
 References

저자정보

  • Il Je Cho Division of Nuclear Fuel Process Development, Korea Atomic Energy Research Institute, Daejeon, Korea; Department of Nuclear Engineering, Hanyang University, Seoul, Korea
  • Jee Hyung Sim Department of Nuclear Engineering, Hanyang University, Seoul, Korea
  • Yong Soo Kim Department of Nuclear Engineering, Hanyang University, Seoul, Korea

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      0개의 논문이 장바구니에 담겼습니다.