원문정보
Comparison of Phosphate Recovery Potential from Alum, PAC, FeSO4 Coagulation Sludge and Return Sludge Ash using Various Chemical Agents
초록
영어
As the phosphorus standard in the sewage effluent was strengthened, the phosphorus treatment facilities in the sewage treatment plants have been installed and operating, and coagulation sludge was generated. And it is a growing need for sludge recycling to the prohibition of ocean dumping. As the Korea is dependent on imports of phosphate rock annually, It is necessary to recover the available phosphate from the coagulation sludge. Therefore, phosphate recovery efficiencies were tested according to various operation parameters. In this study, Alum, FeSO4, PAC coagulation sludges and biological sewage sludge were studied for phosphate dissolution effciency and each of the three acid solutions two alkaline solutions were used for. The dissolution experiments on Alum, FeSO4, and sewage sludge showed the highest concentration of phosphate in the H2SO4 leaching solution and the coagulation sludge using PAC showed best phosphate recovery from the KOH leaching solution. Conclusionally, the phosphate leaching potential followed the order “return sludge ash (3,740 mg/L) > Alum sludge (2,600 mg/L) > FeSO4 > PAC (646 mg/L) sludge.
한국어
방류수의 총인농도가 강화됨에 따라 하수처리장에 총인처리시설이 설치 및 운영되고 있으며 이에 따라 인 응집슬러지가 추가로 발생하고 있으나 발생 슬러지의 해양투기 금지로 총인처리 슬러지의 재이용 필요성이 커지고 있다. 또한 우리나라는 매년 인광석을 전량 수입에 의존하고 있는 실정이므로 폐기되는 인을 회수하여 다시 사용 가능한 순환자원으로재이용할 필요가 있으므로 총인제거 슬러지의 인 회수 특성에 대해 연구를 수행하였다. 본 연구에서는 Alum, FeSO4,PAC 응집슬러지와 생물학적 하수슬러지를 이용하여 각각 세 가지 산성용액 HNO3, HCl, H2SO4와 두 가지 알칼리용액KOH, NaOH을 이용하여 인 용출 실험을 수행하였다. Alum과 FeSO4, 하수슬러지에 대한 용출실험에서는 용출액 중H2SO4이 가장 높은 농도의 인을 회수 하였으며, PAC를 이용한 인 응집 슬러지에 대한 용출실험에서는 KOH 용출액에서 최대 인을 회수율을 나타내었다. 최종적으로 여러 가지 용매에 따른 인 용출량은 “하수슬러지 회분(3740 mg/L) > Alum 인응집 슬러지(2600 mg/L) > FeSO4 인 응집슬러지 > PAC(546 mg/L)”의 순으로 나타났다.
목차
요약문
I. 서론
II. 연구 방법
1. 대상슬러지 시료 및 시료채취
2. 응집슬러지 인 회수 실험
3. SEM과 EDS를 이용한 표면분석
III. 결과 및 고찰
1. Alum 슬러지의 인 용출결과
2. 철염 슬러지의 인 용출결과
3. PAC 슬러지의 인 용출결과
4. 하수슬러지의 인 용출 결과
5. 효율 비교
6. 응집슬러지와 반송슬러지 회분(Ash)의 미세구조와 표면분석
IV. 결론
References
