earticle

논문검색

Design and Construction of Nitrogen Liquefier

초록

영어

The design and construction of nitrogen liquefier begins with the process design of the cycle. The simulation of the cycles has been done using the software Aspen HYSYS. The compressor unit is available in the laboratory. Two number of high effectiveness, vacuum brazed aluminum plate fin heat exchangers are designed and fabricated. Turboexpander is designed and all of its components are fabricated. A suitable modification has been done with a precession needle valve to operate as a long stem JT valve. For separating the liquid, a phase separator is designed and fabricated. All the components are assembled inside a double walled cold box with pipes as per the process need. The necessary pressure, temperatureand other measuring instruments, valves and safety devices are mounted on the liquefier. After successful running of the liquefier, for the mass flow rate of 296 kg/hr for gaseous nitrogen, it is expected to deliver 17.44 lit/hr of liquid nitrogen.

목차

ABSTRACT
 1. INTRODUCTION
 2. DESIGN OF THE COMPONENTS
  2.1 Compressor
  2.2 Design of plate fin heat exchanger
  2.3 Design of turboexpander
 3. FABRICATION OF THE COMPONENTS
  3.1 Heat exchangers
  3.2 Turboexpander
  3.3 J-T expansion valve
  3.4 Phase separator
  3.5 Cold box
 4 INSTRUMENTATION
  4.1 Temperature measurement
  4.2 Pressure measurement
  4.3 Measurement of flow rate
  4.4 Turbine speed measurement
 5. ASSEMBLY OF THE COMPONENTS
 6. CONCLUSION
 REFERENCES

저자정보

  • B. K, Choudhury C.V. Raman College of engineering, Bhubaneswar, India
  • R. K. Sahoo National Institute of Technology Rourkela, Rourkela, India
  • S. K. Sarangi National Institute of Technology Rourkela, Rourkela, India

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      ※ 기관로그인 시 무료 이용이 가능합니다.

      • 4,000원

      0개의 논문이 장바구니에 담겼습니다.