원문정보
초록
영어
To analyze the influence caused by different cutting parameters on the cutting force and get the coefficient of milling force obtained under the state of high-speed milling, the high-speed milling test was conducted through carbide cutting tools milling the titanium impeller under the state of high speed. Firstly, the influence on the three target force, caused by every parameter, was analyzed through orthogonal experiment. And then, the milling force coefficient got from two different formula was compared in this article. Calculated and experimental results show that the milling force coefficient got by means of the empirical formula reduced flutter stability limit, however, he milling force coefficient got by means of parsing not. At last, it also provide data to support to avoid the chatter occurred between tool and workpiece and select the processing parameters optimally.
목차
1. Introduction
2. The Design of the Experimental Scheme
2.1. The Experimental Equipment and Parameters
2.2. The Experimental Tools and Materials
2.3. The Experimental Scheme
3. The Result Analysis
3.1. Analysis of the Process of Obtained Cutting Force Data
3.2. The Influence on, of Various Factors, on Milling Force and the Optimal Scheme
3.3. The Acquisition and Optimal Selective Way of Milling Force Coefficient
3.4. Effects of Different Cutting Force Coefficient on the Stability Limit
4. Conclusion
Acknowledgements
References