원문정보
피인용수 : 0건 (자료제공 : 네이버학술정보)
초록
영어
A corrosion experiment with 20G has been carried out by simulating the environment of heating surface in biomass boilers. Corrosion dynamic curves were obtained by mass gain method. Analysis of the corrosion characteristics were combined with the surface morphology. And the surface morphology and chemical composition of the specimen after experiment were analyzed by using the energy dispersive spectrometer (EDS) and scanning electron microscopy (SEM). The result of experiment show that there is certain corrosion resistance in 20G at a temperature of 500℃, the corrosion strength of chlorine is greater than sulfur during corrosion process, and the deposition corrosion is dominant.
목차
Abstract
1. Introduction
2. Corrosion Simulation Experiment
2.1. Experiment System
2.2. Preparation of Specimens
2.3. Experiment Method
3. Experiment Results and Analysis
3.1. Comparison of Effect on Corrosion Performance at Different Temperature
3.2. Comparison of Effect on Corrosion Performance of O2
3.3. Comparison of Effect on Corrosion Performance of Cl and S
3.4. Comparison of Effect on Corrosion Performance of Flue Gas and Deposition
4. Conclusions
Reference
1. Introduction
2. Corrosion Simulation Experiment
2.1. Experiment System
2.2. Preparation of Specimens
2.3. Experiment Method
3. Experiment Results and Analysis
3.1. Comparison of Effect on Corrosion Performance at Different Temperature
3.2. Comparison of Effect on Corrosion Performance of O2
3.3. Comparison of Effect on Corrosion Performance of Cl and S
3.4. Comparison of Effect on Corrosion Performance of Flue Gas and Deposition
4. Conclusions
Reference
저자정보
참고문헌
자료제공 : 네이버학술정보