원문정보
보안공학연구지원센터(IJUNESST)
International Journal of u- and e- Service, Science and Technology
Vol.8 No.5
2015.05
pp.323-328
피인용수 : 0건 (자료제공 : 네이버학술정보)
초록
영어
To nickel base superalloy in dry cutting, the milling experiment be done in the four-axis machining center with ceramic tool WG300 is in order to know the influence of cutting speed to chip morphology through the macroscopic observation on chip by optical microscope and the analysis of chip morphology. Then, focus on the machining features of GH3039, reasonable orthogonal test be designed, after which getting the influence of different level’s value to milling force and its change law based on the range analysis of experiment datum.
목차
Abstract
1. Instructions
2. Experiment Condition and Project
2.1. Experimental Facilities and Tool
2.2. Experimental Project
2.3. Range Analysis of Experiment
3. Conclusions
Acknowledgements
References
1. Instructions
2. Experiment Condition and Project
2.1. Experimental Facilities and Tool
2.2. Experimental Project
2.3. Range Analysis of Experiment
3. Conclusions
Acknowledgements
References
저자정보
참고문헌
자료제공 : 네이버학술정보