원문정보
피인용수 : 0건 (자료제공 : 네이버학술정보)
초록
영어
This paper introduces a design and realization method of battery management system about emergency light based on time division multiplexing and balanced charging technology. Through Calculating state of electric charge by detecting the battery charge and discharge current and monitoring of a single voltage, the system achieves a balanced charge control methods and strategies, avoided battery overcharge and over-discharge, and further improves the efficiency of the battery, extending the battery life.
목차
Abstract
1. Introduction
2. Hardware Design
2.1. Hardware Overall Design
2.2 Microprocessor
2.3 SMBus I / O bus
2.4 Current Measurement
2.5 Single Voltage Measuring and Balance Control
2.6 Detection and Control Methods Device of Powered
2.7 IR Remote Control
2.8 Charge Management
2.9 Discharge Management
3. System Software Design
3.1 Acquisition and Single Voltage Balancing
3.2 Single Battery Control Methods of Charge Balance
4. Implemented Measuring System Compositon
4.1 Signal Detection
4.2 Control Signal
4.3 Power Supply
4.4 Ventilation Cooling
4.5 Charging Control
5. Conclusion
References
1. Introduction
2. Hardware Design
2.1. Hardware Overall Design
2.2 Microprocessor
2.3 SMBus I / O bus
2.4 Current Measurement
2.5 Single Voltage Measuring and Balance Control
2.6 Detection and Control Methods Device of Powered
2.7 IR Remote Control
2.8 Charge Management
2.9 Discharge Management
3. System Software Design
3.1 Acquisition and Single Voltage Balancing
3.2 Single Battery Control Methods of Charge Balance
4. Implemented Measuring System Compositon
4.1 Signal Detection
4.2 Control Signal
4.3 Power Supply
4.4 Ventilation Cooling
4.5 Charging Control
5. Conclusion
References
저자정보
참고문헌
자료제공 : 네이버학술정보