earticle

논문검색

Characteristic of wireless power transmission S-Parameter for a superconductor coil

초록

영어

Many studies are being conducted to implement wireless charging, for example, for cellular phones or electronic tooth brushes, via wireless power transmission technique. However, the magnetic induction method had a very short transmission distance. To solve this problem, the team of Professor Marin Soljacic proposed a magnetic resonance system that used two resonance coils with the same resonance frequency. It had an approximately 40% efficiency at a 2m distance. The system improved the low efficiency and short distance problems of the existing systems. So it could also widen the application range of wireless power transmission. Many studies on the subject are underway. In this paper, the superconductor coil was used to improve the efficiency of magnetic resonance wireless power transmission. The resonance wireless power transmission system had a source coil, a load coil, and resonance coils (a transmitter and a receiver). The efficiency and distance depended on the characteristics of the transmitter and receiver coils that had the same resonance frequency. Therefore, two resonance coils were fabricated by superconductors. The current density of the superconductor was higher than that of the normal conductor coil. Accordingly, it had a high quality-factor and improved efficiency

목차

Root
 Abstract
 1. INTRODUCTION
 2. MAIN PARAMETERS
  2.1. WPT diagram
  2.2. Quality-factor
  2.3. Coil Design
 3. EXPERIMENT
  3.1. Experiment composition
  3.2. Experiment analysis
 4. CONCLUSION
 ACKNOWLEDGMENT
 REFERENCES

저자정보

  • In-Sung Jeong Chosun University, Gwangju, Korea
  • Byung-Ik Jung Chosun University, Gwangju, Korea
  • Hyo-Sang Choi Chosun University, Gwangju, Korea

참고문헌

자료제공 : 네이버학술정보

    ※ 기관로그인 시 무료 이용이 가능합니다.
    ※ 학술발표대회집, 워크숍 자료집 중 4페이지 이내 논문은 '요약'만 제공되는 경우가 있으니, 구매 전에 간행물명, 페이지 수 확인 부탁 드립니다.

    • 4,000원

    0개의 논문이 장바구니에 담겼습니다.