Research and Development of Ethernet Communication System in Numerical Control Workshop

Wang Qingcheng; Cao Guohua; Mao Ning

Research and Development of Ethernet Communication System in Numerical Control Workshop

원문정보

Wang Qingcheng, Cao Guohua, Mao Ning

보안공학연구지원센터(IJFGCN) International Journal of Future Generation Communication and Networking Vol.7 No.6 2014.12 pp.51-58

피인용수 : 0건 (자료제공 : 네이버학술정보)

초록

영어

There are 10 sets of CNC equipment in a numerical controlled workshop, and set up the CAD/CAPP/CAM center, there is a problem that each production unit is an information island, which can not implement informatization management. This paper takes ZNE-100TL module realized the embedded Ethernet and RS-232C data transfer function as the hardware platform, takes VC++ as software platform, applied Ethernet technology to realize communication the CNC equipment with CAD/CAPP/CAM center. This is good for production management and data transmission in numerical controlled workshop, which can improve the production efficiency.

Abstract
1. Introduction
2. Hardware Design
  2.1. Overall Design
  2.2. Ethernet and RS-232C Data Conversion Module
3. Software Design
  3.1. Operation Interface Design
  3.2. Program Flow
4. Communications Function
  4.1. Alarm Function
  4.2. Data Transmission Function
5. Experimental Verification
6. Conclusion
Acknowledgements
References

키워드

저자정보

Wang Qingcheng School of Mechanical Engineering, Jilin Teachers’ Institute of Engineering and Technology, Changchun 130052, China
Cao Guohua School of Mechanical and Electric Engineering, Changchun University of Science and Technology, Changchun 130022, China
Mao Ning China North Vehicle Research Institute, Beijing 100072, China

참고문헌

자료제공 : 네이버학술정보

함께 이용한 논문

※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.

0개의 논문이 장바구니에 담겼습니다.

earticle