earticle

논문검색

Comparison of Cylindrical and Conical Helical Springs for their Buckling Load and Deflection

초록

영어

Buckling behavior of cylindrical helical springs subjected to axial load has already been illustrated in the past theories. Unlike cylindrical spring, the behavior of conical compression spring has both linear and nonlinear phase. Very little literature on buckling of conical springs can be found in the past. In this paper, an analytical buckling equation with its experimental verification has been proposed by authors and used it along with the existing theories to locate the phase of compression of conical spring at which buckling occurs. Subsequently, a comparison between cylindrical and conical springs has been made at the point of buckling of cylindrical spring in respect of their load and deflection. This would help to decide the suitability of conical springs against buckling failure of cylindrical springs under the given operating conditions.

목차

Abstract
 1. Introduction
 2. Literature Review
 3. Methodology
  3.1 .Theoretical Analysis for Cylindrical Helical Compression Springs
  3.2 .Numerical Illustration
  3.3. The Outcomes of Theoretical Analysis has been shown in Table 2 as Given Below.
  3.4 Theoretical Analysis for Conical Helical Compression Springs
 4. Conduct of Experiments
  4.1 Test Rig
  4.2 Experimental Data
 5. Results and Discussion
 6. Conclusion
 References

저자정보

  • Rajkumar V. Patil Rajiv Gandhi Institute of Technology,Juhu-Versova,LinkRoad, Andheri(w), Mumbai-400053, India
  • P. Ravinder Reddy Department of Mechanical Engineering, Chaitanya Bharati Institute of Technology, Gandipet, Osman Sagar, Hyderabad-50075, India
  • P. Laxminarayana Department of Mechanical Engineering, University College of Engineering, Osmania University, Hyderabad-500007, India

참고문헌

자료제공 : 네이버학술정보

    ※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.

    0개의 논문이 장바구니에 담겼습니다.