원문정보
피인용수 : 0건 (자료제공 : 네이버학술정보)
초록
영어
Vibration characteristic of mechanical system is the main factor affecting machine tool accuracy and longevity. The HTM50200 CNC with eight axles and double five-axis linkage was tested by a self-made vibration test system. The dynamic characteristic and fault diagnosis was analyzed by using the method of cepstrum identification on the vibration signal of X, Y, Z direction of the principal axis front. Analysis shows that the machining center has good dynamic characteristics, and has no obvious potential problems; the machining center is greatly influenced by Spindle cutter handle system; obtain the optimal processing parameters for machining center.
목차
Abstract
1. Introduction
2. Fault Signal Characteristics
2.1. Failure Characteristics of Shaft and Shaft System
2.2. The Fault Signal Characteristics of Rolling Bearing
3. Vibration Test System
3.1. Self-made Vibration Test System
3.2. Testing Scheme and Equipment
4. Dynamic Test and Analysis of HTM50200 CNC
4.1. Empty Running Test Analysis
4.2. Cutting Test Analysis
5. The Test Results Analysis
6. Conclusion
Acknowledgements
References
1. Introduction
2. Fault Signal Characteristics
2.1. Failure Characteristics of Shaft and Shaft System
2.2. The Fault Signal Characteristics of Rolling Bearing
3. Vibration Test System
3.1. Self-made Vibration Test System
3.2. Testing Scheme and Equipment
4. Dynamic Test and Analysis of HTM50200 CNC
4.1. Empty Running Test Analysis
4.2. Cutting Test Analysis
5. The Test Results Analysis
6. Conclusion
Acknowledgements
References
저자정보
참고문헌
자료제공 : 네이버학술정보