earticle

논문검색

Design of Sliding Mode Controller with Auto-tuning Method

원문정보

Wei He, Yujia Zhai

피인용수 : 0(자료제공 : 네이버학술정보)

초록

영어

Sliding mode control(SMC) are carried out in this literature. And to make the controllers perform better, fuzzy logic was chosen,it makes PID controller auto-tuning parameters and reduced the chattering problem of sliding mode control. Since SMC take error and derivative of error as inputs, after comparison some results are obtained.PID controller response faster yet sliding mode control is much steadier. However certain problems cannot be ignored that the chattering phenomenal cannot be reduced entirely and this motion may hurt the machine; this project only considered a simple system, there is no guarantee PID can work as well as in this case for a much more complex system. MATLAB simulink was the main approach to obtain the performance of the two controllers: to observe the control output of the two controllers, electric circuit and special controllers are designed and tested in MATLAB.

목차

Abstract
 1. Introduction
 2. Sliding mode control (SMC)
  2.1 Stability
  2.2 Sufficient condition
  2.3 Design of sliding manifold
 3. Design and simulation
 4. Comparison with SMC and autotuning PID
 5. Conclusion
 Reference

저자정보

  • Wei He Automatic Control and System Engineering, University of Sheffield Flat 19C, Opal 2, Brightmore House, 12 St. George's Close, Sheffield, S3 7HD, England
  • Yujia Zhai Department of Electrical and Electronics Engineering, Xi’an Jiaotong-Liverpool University, Suzhou, China

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      ※ 기관로그인 시 무료 이용이 가능합니다.

      • 4,000원

      0개의 논문이 장바구니에 담겼습니다.