원문정보
보안공학연구지원센터(IJMUE)
International Journal of Multimedia and Ubiquitous Engineering
Vol.9 No.1
2014.01
pp.143-152
피인용수 : 0건 (자료제공 : 네이버학술정보)
초록
영어
In this study, it is proposed to use software to create MDDI protocol packet which is required for the display device. The previously proposed method to create MDDI protocol packet was implemented in FPGA. In the previous MDDI interface design method, data and synchronization signal were created inside of the FPGA chip. FPGA chip creates data received from CPU into serial data and creates packets and then controls signals. This design method is intended to reduce CPU load. In this paper, the method of creating data in software, which was notpresent in the previous FPGA is proposed for design of data transmitter using the MDDI interface method.
목차
Abstract
1. Introduction
2. Hardware and Software Designs
2.1. Hardware design
2.2. Software design
3. Measurement Result and Consideration
3.1 Sub-frame header packet
3.2 Video stream packet
3.3 Link shutdown packet
3.4 Register access packet
3.5 Link hibernation
5. Conclusion
References
1. Introduction
2. Hardware and Software Designs
2.1. Hardware design
2.2. Software design
3. Measurement Result and Consideration
3.1 Sub-frame header packet
3.2 Video stream packet
3.3 Link shutdown packet
3.4 Register access packet
3.5 Link hibernation
5. Conclusion
References
저자정보
참고문헌
자료제공 : 네이버학술정보