earticle

논문검색

Wideband Tri-band Filter Design using Stepped-impedance Stub Resonators

초록

영어

This letter presents a wideband tri-passband filter in which tri-section stepped-impedance shunt-stubs are used as tri-mode resonators, connected by transmission lines. Developed from the topology of quarter-wavelength stub filters, these filters have much wider passbands compared to many other designs published. The stepped-impedance stubs also contribute transmission zeros between the passbands, thus increasing the isolation. A prototype filter with passbands located at 0.6-1, 1.5-1.8 and 2.2-2.4 GHz is designed by an optimization method. Good agreement between simulation and measurements in respect of low insertion loss and high isolation is demonstrated.

목차

Abstract
 1. Introduction
 2. Tri-section Stepped-impedance Stub and Tri-band Filter
 3. Results and Discussion
 References

저자정보

  • Mengmeng Cui Jiangsu Engineering Center of Network Monitoring, Nanjing University of Information Science & Technology, School of Applied Meteorological Science, Nanjing University of Information Science & Technology
  • Yun Liu College of Electronic and Information Engineering, Nanjing University of Aeronautics and Astronautics
  • Shengjun Xue Jiangsu Engineering Center of Network Monitoring, Nanjing University of Information Science & Technology
  • Jin Wang Jiangsu Engineering Center of Network Monitoring, Nanjing University of Information Science & Technology

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      ※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.

      0개의 논문이 장바구니에 담겼습니다.