earticle

논문검색

다공질 구조체를 사용한 샌드위치 패널의 난연성능에 관한 연구

원문정보

A Study on Flame Resistance Performance of Sandwich Panel with Porous Material

이택운, 심운준

피인용수 : 0(자료제공 : 네이버학술정보)

초록

영어

The use of sandwich panel spread rapidly for commercial and housing construction for its conveniency of construction, economic construction cost and excellent insulation. As the finishing material is non flammable iron plate, combustibility test in KS F 2271 does not properly reflect the fire risk of panel core, and there is no active development on core yet. In this study, porous structure panel was fabricated for combustibility test of sandwich panel. This study performed surface test and gas toxic ingredients test for the porous structure panel together with polystyrene panel (EPS panel), urethane foam panel, and glass wool panel on the basis of the KSF 2271 "Method for combustibility test in interior resources of structure and its structure." The results are as follows. The porous structure panel fabricated in this study began to extinct from bottom part after 5 minutes when direct heat 500°C in 5cm distance was applied based on the surface test, and died out the lowest part in 10 minutes. When direct fire with torch in 10cm distance was added, it began to burn in 76 seconds with white smoke. No toxic gas such as HCL< HCN and HF was detected when quantitative analysis for combustion gas toxicity was peformed. Further tests and researches are needed to satisfy essential requirements as insulation performance of porous structure and interior and exterior material for sound insulation construction.

한국어

샌드위치 패널은 시공편리성, 경제적인 공사비용, 뛰어난 단열성능으로 현재 상업용과 주거 건축용으로 급속히 확산 되고 있다 .패널의 특성상 불연소재인 철판으로 마감되어있기 때문에, KS F 2271의 난연시험에서 패널 심재(core)의 화재위험성이 제대로 반영되지 못하고 있고 심재개발 또한 활발히 진행되어지고 있지 않다. 본 연구는 샌드위치 패널의 난연 성능 향상을 다공질 구조체 패널을 제작 한 후 현재 상용되고 있는 스티로폼패널(EPS패널), 우레탄폼패널, 글라스울 패널 등과 함께 시험방법은KS F 2271 "건축물의 내장재료 및 구조의 난연성 시험방법“을 토대로 표면시험과 가스 유해성 시험을 실시하였다. 본 연구의 결과는 다음과 같다. 본 연구에서 제작한 다공질 패널은 표면시험에 의거 500°C, 5cm간격 직열을 가할시 5분 경과 후 하부 일부소멸이 시작되어 10분경과시 최하층이 소멸되었다. 또한 토치로 10cm 간격으로 직화시 1분 16초에 발화와 함께 흰 연기가 발생하였다. 가열시 발생한 연소가스유해성 정량분석 결과 유독가스인 HCL, HCN, HF 등이 검출되지 않았다. 이후 다공질구조체의 단열성능과 차음성능 건축 내외장재로서의 필수 요구조건에 대한 추가적인 시험과 연구가 요구되어진다.

목차

Abstract
 1. 서론
 2. 시험개요
  2.1 사용재료
  2.2 국내 난연성능 규격과 판정기준
 3. 시험방법
  3.1 난연성능 시험방법
  3.2 콘칼로리미터 시험과 유해성 연소가스 분석
 4. 시험 결과 및 고찰
  4.1 표면시험
  4.2 가스유해성시험 결과
  4.3 FTIR을 이용한 유해성 연소가스 시험분석
  4.4 콘칼로리미터 시험
 5. 결론
 참고문헌

저자정보

  • 이택운 Lee, Taick-Oun. 영남이공대학 토목·건축학부 건축과 부교수
  • 심운준 Shim, Un-Jun. 영남대학교 건축학부 겸임교수

참고문헌

자료제공 : 네이버학술정보

    함께 이용한 논문

      ※ 기관로그인 시 무료 이용이 가능합니다.

      • 4,000원

      0개의 논문이 장바구니에 담겼습니다.